Dry Quickly
Remove Unsalvagable Material
|
Dry items before mold grows, if possible. In most cases, mold will not grow if wet or damp items are dried within 24-48 hours.
To dry carpet and backing within 48 hours, remove water with a wet vacuum, pull the carpet and pad off the floor, and dry them using a fan to blow air over them. A dehumidifier can be used to reduce the humidity in the room where the carpet and backing are drying, while fans can be used to accelerate the drying process.
Spray
Moldstat: In all in all areas, to avoid any mold growth.
Water can be removed from concrete or cinder block surfaces with a water-extraction vacuum. The drying also can be accelerated by using dehumidifiers, fans, and heaters.
Hard surface flooring (such as linoleum, ceramic tile, and vinyl) should be vacuumed or damp wiped with a
Moldstat: and allowed to dry. They should be scrubbed clean, if necessary. If the under-flooring is wet, it should be dried using a vacuum or by exposing it to the air.
Non-porous, hard surfaces such as plastics and metals should be vacuumed or damp wiped Moldstat:, then allowed to dry. Scrubbing may be necessary to thoroughly clean the surfaces.
Water should be removed from upholstered furniture with a water-extraction vacuum. Fans, dehumidifiers, and heaters may be used to accelerate the drying process. Completely drying upholstered furniture within 48 hours may be difficult, so if the piece is valuable, you may consider consulting a restoration or water-damage professional who specializes in furniture.
Drywall, also known as gypsum board or gypsum wallboard, may be dried in place if there is no obvious swelling and the seams are intact. Otherwise, removal is necessary. The wall cavity is the most difficult area to dry, and it should be ventilated if drywall is left to dry in place. (Drywall is not made out of boards of wood; traditionally, drywall is made of the mineral gypsum with a layer of heavy paper on the outside and inside. Commercial gypsum boards and drywall are also available with a variety of outside layers and coatings. According to the U.S. Geological Survey, a typical new home contains more than 7 metric tons of gypsum.)
To clean water-damaged window drapes, follow the manufacturer's laundering or cleaning instructions.
To clean
wooden surfaces, remove moisture immediately and use dehumidifiers, fans, and gentle heat to dry them. (Be very careful when applying heat to hardwood floors.)
Treated or finished wood surfaces can be cleaned with
Moldstat:, then allowed to dry. Wet
paneling should be pried from the wall for drying.
Some water-damaged items, including ceiling tiles, cellulose and fiberglass insulation, drywall and gypsum board, and books and papers, may have to be discarded. If valuable or important books, documents, or other items are moldy or water damaged, you may wish to consult a restoration, water damage, or remediation expert.
